fret slot depth
Fret slotting runout - Shapeoko
Fret slotting runout - Shapeoko
Fret slotting runout - Shapeoko fret slot depth Dan Erlewine developed this remarkably handy look-before-you-leap gauge for quickly comparing the wire to the slot Simply hold the flat edge against the fret fret slot width The guides can be adjusted to match the blade precisely You can quickly slot any board up to 3 wide The position of the fret slots can be measured out
fret slot width Thanks for the reply Fret slot depth should conform to the curve of the top of fretboard, remaining a constant depth approx 3mm Top
fret slot saw You never want the slot too shallow, that's for sure Still, most companies cut deep slots to account for leveling, inlays & sanding, different Fret slots are deeper than fret tangs? Not a big deal But if want to fill those areas, get a small piece of rosewood (or something equally